Educate

Combining a Magnetic Level Gauge with Level Switches and Level Transmitters for Automatic Alarms and Monitoring

AAndreas Budi Ekayana November 04, 2026 3 min read 44 views
Combining a Magnetic Level Gauge with Level Switches and Level Transmitters for Automatic Alarms and Monitoring

A magnetic level gauge gives the operator a clear reading while standing in front of the tank. The trouble is that operators are not always there. On a night shift, a genset diesel tank can run empty with nobody watching, and a chemical tank can overflow when someone forgets to stop the transfer pump. By adding level switches and a level transmitter to the same chamber, one magnetic level gauge becomes a complete measuring point for local reading, alarms and remote monitoring.

A magnetic level switch is clamped to the outside of the chamber, with no extra nozzle needed on the tank. As the float passes the switch, its magnetic field operates a contact inside. That contact can drive an alarm lamp or buzzer directly, or go into a PLC digital input. Because the switch can slide along the chamber, alarm points can be reset in the field when process needs change.

A common arrangement is two to four switches per chamber. A high-high switch at the top prevents overflow, a high switch stops the filling pump, a low switch starts the transfer pump, and a low-low switch protects the pump from running dry. On a genset day tank, for example, the low switch can start the pump from the bulk tank and the high switch stops it, so refilling runs automatically without an operator.

For continuous data, a level transmitter is mounted alongside the chamber. It reads the position of the float magnet along its sensor tube and converts it into a 4–20 mA signal proportional to level. The signal goes to a PLC, DCS or digital panel meter, so the control room can view the level as a percentage or volume, log trends and work out daily consumption. The transmitter reading and the local colour column come from the same float, which makes them easy to compare during checks.

The combination also adds a layer of protection. If the transmitter fails or its cable is cut, operators can still read the level on the indicator. If the control system has a fault, the level switches still raise alarms through a separate circuit. For safety functions, the high-high alarm switch is best wired into a circuit that does not depend on the transmitter.

Planning is best done at the ordering stage. Decide how many switch points are needed and their positions from the bottom nozzle, the contact type required (normally open or normally closed), and the transmitter output range. If the tank sits in an area with flammable vapours, the switches and transmitter need housings suited to the area classification, such as explosion-proof enclosures, and installation must follow the applicable hazardous area rules.

This arrangement is widely used on genset diesel tanks in buildings and factories, chemical tanks in water treatment plants, product tanks in food processing and storage tanks at fuel terminals. One chamber delivers three functions without adding a single opening to the tank wall.

CV. Rach Tekindo Makmur supplies Magnetic Level Gauge Indicators for a wide range of industrial instrumentation needs. If you need level gauges, level switches, level transmitters, or consultation on configuration and installation for your level measurement system, contact us on WhatsApp at 0877-8620-5656 to discuss your technical requirements and request a quotation tailored to your application.

Need help choosing an instrument?

Our team is ready to help you find the right product for your needs.

Chat on WhatsApp

Read 44 times.

Related Articles

Link copied